Indeed it is in host mode hprt0 = 00001101
usb 1-1: new high-speed USB device number 2 using dwc_otg mmc0: new high speed SDHC card at address e624 mmc0: host does not support reading read-only switch, assuming write-enable Indeed it is in host mode hprt0 = 00021501
usbcore: registered new interface driver usbhid hidraw: raw HID events driver (C) Jiri Kosina ledtrig-cpu: registered to indicate activity on CPUs sdhci-pltfm: SDHCI platform and OF driver helper DMA channels allocated for the MMC driver sdhci: Secure Digital Host Controller Interface driver mousedev: PS/2 mouse device common for all mice usbcore: registered new interface driver usb-storage dwc_otg: FIQ split-transaction FSM enabled If analog input isn’t strictly necessary to you, you can try to map one of the sticks as a d-pad and adjust its dead zone if you still have phantom menu navigation.Usb usb1: SerialNumber: bcm2708_usb The same problem has been observed on other brands like Buffalo and Wii. Even genuine brand-new controllers may or may not suffer this issue. The controller sends very short key presses (usually d-pad directions) that are commonly ignored by games, but might be noticed outside them. That’s a problem with the controller itself rather than RetroPie. Ghost inputs, controller sending key presses on its own To disconnect the controller, hold down the ps3 button for 10 seconds.
Refer to here: Connection issues and input lags especially if you connect more than one BT device Disconnect Bluetooth Controller Note: Do not enable other bluetooth options as these will conflict with the PS3 specific bluetooth setup (sixad) FAQ Input lags or problems to connect more than 2 players Hold any button down on the controller to begin configuring it.Īnd you now have a functional PS3 controller over Bluetooth. Step 7 – Emulation Station should now detect another gamepad connected. The controller should now be connected via Bluetooth. You should see the lights on it flash sequentially. Step 6 – Disconnect your PS3 controller from USB. Step 5 – Press “Start” to enter the EmulationStation Menu, and select Configure Input. Step 4 – Once installation completes, exit RetroPie setup and return to the EmulationStation Home Screen. Step 3 – Select PS3 Controller Driver (“ps3controller”), and then select.
Step 2 – Once in the RetroPie GUI, choose >. Step 1 – Navigate to the “RetroPie” icon in the Home Screen and select it using whatever key you mapped “A” to on your gamepad, and go to RetroPie Setup Using the RetroPie GUI to configure the PS3 Controller Bluetooth Connection Once you’re in the terminal, follow these instructions to run the retropie_setup.sh script.
If you are overclocking, for example, it will be much safer to use a powered USB hub than drawing current from the Pi itself.Īfter your Pi boots up, you need to enter RetroPie setup. While a separate powered USB hub is not required to set up a controller, be mindful of your overall power draw when attaching peripherals. If you have a Playstation 3 console near by, make sure it is totally powered off–either unplugged or switched off in the back–because the PS3 controller may try to automatically pair with the console otherwise. Note: These controllers have been tested using the latest version of RetroPie v4.6 Configuring a PS3 controller to connect via Bluetoothīefore booting the Raspberry Pi, make sure that a supported Bluetooth adapter is connected (for the Pi 3, onboard Bluetooth works perfectly as of RetroPie 4.0+). Connecting a PS3 controller via Bluetooth requires installation of a special PS3 driver located in RetroPie setup. Connecting over USB is Plug-and-Play–literally just plug your controller into the Pi while EmulationStation is running and it should detect a gamepad to configure. The most recent versions of RetroPie include the packages needed for setting up a PS3 controller.